Motor starter clicks but the motor will not start
A click with no spin is often a capacitor, a jam, or a dead winding. Stop hammering the switch. Check voltage and the starter, then call the rewind shop if it smells hot.
Motor & Boring
Tripping motors, burned windings, submersible sand, boring depth permits, and dry handpumps.
The handpump went dry and the monsoon is late
A village handpump that sucks air is a summer signal. Do not keep pumping. Check other pumps in the cluster and ask the panchayat which tanker or scheme is on paper.
We need to increase boring depth — who issues the permit?
Deeper is not a DIY decision. District groundwater or the municipal permit desk is the place to ask. Banned or notified areas will say no, and that is the rule.
Submersible boring is throwing sand and very little water
Sand in the tank means the strainer or the aquifer is unhappy. Running longer will chew the impeller. Check yield, not just the sound of the motor.
Dry run burned the motor — will warranty still help?
Most domestic pump warranties skip dry-run damage. A float switch, a dry-run sensor, and a written service note matter more than shouting at the shop.
Motor keeps tripping, MCB is fine — winding may be the suspect
If the starter clicks and the motor dies in two minutes, do not keep restarting. Heat, a dry suction, or a weak winding will finish the pump.